Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-338001.png)
Cylinder Head Gasket: Service and Repair
REPLACEMENT
1. WORK FOR PREVENTING GASOLINE FROM SPILLING OUT
2. REMOVE FRONT WHEEL RH
3. REMOVE ENGINE UNDER COVER RH
4. DRAIN COOLANT
5. REMOVE CYLINDER HEAD COVER NO.2
a. Remove the 3 bolts, the nut and the cylinder head cover No. 2.
6. REMOVE AIR CLEANER ASSEMBLY WITH HOSE
a. Disconnect the MAF meter connector.
b. Place match marks on the vacuum hoses.
c. Disconnect the 5 vacuum hoses from the air cleaner cap.
d. Disconnect the 2 clamps, and disconnect the air cleaner cap from the air cleaner case.
e. Loosen the hose clamp bolt, and disconnect the air cleaner hose from the throttle body.
f.
Remove the air cleaner assembly with hose.
7. DISCONNECT ACCELERATOR CONTROL CABLE ASSY
8. REMOVE WIRE HARNESS CLAMP
a. Disconnect engine wire harness.
b. Remove the bolt and wiring harness clamp bracket.
9. DISCONNECT SUCTION HOSE SUB-ASSY
a. Remove the 2 nuts installing the suction hose sub-assy.
b. Disconnect the suction hose sub-assy.
