Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-338002.png)
10. REMOVE FAN AND GENERATOR V-BELT
a. Turn the drive belt tensioner slowly clockwise and loosen it. Then, remove the drive belt and put back the drive belt tensioner little by little
and fix it quietly.
11. REMOVE EFI FUEL PIPE CLAMP
12. DISCONNECT FUEL TUBE SUB-ASSY
13. SEPARATE RADIATOR HOSE INLET
a. Disconnect the radiator hose inlet from the radiator.
14. DISCONNECT HEATER INLET WATER HOSE
a. Disconnect the heater inlet water hose from the air conditioner tube.
15. DISCONNECT WATER BY-PASS HOSE NO.2
a. Disconnect the water by-pass hose No. 2 from the throttle body.
16. DISCONNECT WATER BY-PASS HOSE NO.3
a. Disconnect the water by-pass hose No. 3 from the throttle body.
17. DISCONNECT UNION TO CONNECTOR TUBE HOSE
a. Disconnect the union to check valve hose from the brake booster.
18. REMOVE GENERATOR BRACKET NO.1
19. REMOVE GENERATOR ASSY
20. SEPARATE COMPRESSOR AND MAGNETIC CLUTCH (W/ AIR CONDITIONER)
HINT: Hung up the hoses instead of detaching.
21. DISCONNECT EXHAUST PIPE ASSY FRONT
a. Remove the 2 bolts and 2 nuts compression springs installing the front side of exhaust pipe.
b. Remove the gasket.
22. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSY RH
a. Set the jack to the engine.
HINT: Place a wooden block between the jack and engine.
