Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-338003.png)
b. Remove the 5 bolts, 2 nuts and engine mounting insulator sub-assy RH
23. DISCONNECT ENGINE WIRE
a. Disconnect the ignition coil connectors, oil control valve connector and crankshaft position sensor connector.
b. Remove the bolt and nut for the earth and put the engine wiring side.
24. INSTALL IGNITION COIL ASSY
a. Remove the 4 bolts and the 4 ignition coils.
25. DISCONNECT VENTILATION HOSE
a. Disconnect the ventilation hose from the cylinder head cover.
26. DISCONNECT VENTILATION HOSE: NO.2
a. Disconnect the ventilation hose from the cylinder head cover.
27. REMOVE CYLINDER HEAD COVER SUB-ASSY
a. Disconnect the fuel hose clamp and 2 PCV hoses from the cylinder head cover.
b. Remove the 2 nuts, bolt and disconnect the No. 3 ventilation hose from the No. 1 ventilation pipe.
c. Disconnect the ventilation No. 1 tube and gasket.
d. Remove the 8 bolts, wire harness protector, cylinder head cover and gasket.
e. Remove the O-ring from the cylinder head cover.
