Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-338012.png)
Part No. 08826-00100 or equivalent
-
Install a nozzle that has been cut to a 1.5 mm opening.
HINT: Avoid applying an excessive amount to the surface.
-
Parts must be assembled within 3 minutes of application. Otherwise the material must be removed and reapplied.
-
Immediately remove nozzle from the tube and reinstall cap.
c. Install the 2 gaskets to the timing chain cover an shown in the illustration.
d. Apply seal packing to 4 locations an shown in the illustration.
Seal packing:
Part No. 08826-00080 or equivalent
-
Install a nozzle that has been cut to a 4 - 5 mm (0.16 - 0.20 inch) opening.
HINT: Avoid applying an excessive amount to the surface.
-
Parts must be assembled within 3 minutes of application. Otherwise the material must be removed and reapplied.
-
Immediately remove nozzle from the tube and rein stall cap.
NOTICE: Do not put into engine oil within 2 hours after installing.
e. Install the timing chain cover, with the 12 bolts and nut.
Torque:
21 Nm (214 kgf-cm, 15 ft. lbs.) (M8)
11 Nm (112 kgf-cm, 8 ft. lbs.) (M6)
f.
Install the stud bolt.
Torque: 9.5 Nm (97 kgf-cm, 84 inch lbs.)
64. INSTALL CHAIN TENSIONER ASSY NO.1
a. Check the O-ring is clean, and set the hook as shown in the illustration.
