Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-988008.png)
41. INSTALL ECM
a. Install the ECM with the 2 bolts.
Torque: 3.0 N.m (30 kgf.cm, 26 in.lbf)
NOTE:
-
Do not apply excessive force to the connecter of the ECM.
-
Do not give any impact to the ECM.
42. INSTALL INSTRUMENT PANEL SUB-ASSY LOWER
43. INSTALL AIR CONDITIONING CONTROL ASSY
44. INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSY
a. Set the arm in FACE position.
b. Install the inner cable end to the control lever with the arm in FACE position.
c. Install the outer cable to the cable clamp while slightly pressing it in the direction of the arrow.
NOTE:
-
Be careful not to bend the cable wire.
-
If the cable wire bends, the air conditioning control assy operationality becomes worse.
HINT: Operating the mode control lever, check that it properly stops at both ends of FACE and DEF and no recoil is identified.
45. INSTALL AIRMIX DAMPER CONTROL CABLE SUB-ASSY
a. Set the arm in MAX. COOL position.
b. Install the inner cable end to the control lever with the arm in MAX. COOL position.
c. Install the outer cable to the cable clamp while slightly pressing it in the direction of the arrow.
NOTE:
