Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-1040002.png)
8. INSTALL SEAT POSITION AIR BAG SENSOR
a. Using a torx socket wrench (T30), install the seat position airbag sensor with the torx screw.
Torque: 8.0 N.m (82 kgf.cm, 11 in.lbf)
b. Connect the connector of the seat position airbag sensor.
NOTE:
-
Installation of the connector is done with the sensor assembly installed. Make sure the sensor assembly is installed with the specified
torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the sensor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other
parts.
-
After installation, shake the sensor assembly to check that there is no looseness.
9. INSTALL FRONT SEAT ASSY LH
Torque: 47 N.m (480 kgf.cm, 35 ft.lbf)
10. INSPECT SRS WARNING LIGHT
