Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-931015.png)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
j.
Recheck the total preload.
Preload (turning): 1.0 - 1.8 Nm (10 - 18 kgf-cm, 8.6 - 15.7 ft. lbs.)
k. Remove the RH and LH rack ends.
55. INSTALL STEERING RACK END SUB-ASSY
a. Using a spanner, hold the steering rack steadily and using SST, install the 2 rack ends.
SST 09922-10010
Torque: 62 Nm (630 kgf-cm, 46 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT:
^
Using SST, hold the rack and install the rack and sub assy.
^
Use a torque wrench with a fulcrum length of 380 mm (14.96 inch).
b. Ensure that the steering rack hole is not clogged with grease.
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and steering wheel is turned.
56. INSTALL STEERING RACK BOOT NO.2
a. Install the steering rack boot No.2.
b. Using SST, tighten the steering rack boot No.2 clamp, as shown in the illustration.
SST 09521-24010
Clearance: 3.0 mm (0.118 inch) or less
NOTICE: Be careful not to damage the boot.
c. Using a pliers, install the rack boot clip.
57. INSTALL STEERING RACK BOOT NO.1
