Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
16. REMOVE REAR AXLE CARRIER BUSH LH
a. Make matchmarks on the 2 notches of the bushing and axle beam.
b. Using a chisel and a hammer, bend the 2 portions of the bushing rib.
HINT: Bend the bushing rib until the claw of SST can be hung.
c. Using SST, remove the bushing from the axle beam.
SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-04011), 09950-60010
(09951-00630)
NOTICE: If the rear axle beam assy has been scratched, apply the paint.
17. REMOVE REAR AXLE CARRIER BUSH RH
SST 09950-40011 (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04051, 09957-04010, 09958-4011), 09950-0010
(09951-00630)
HINT: Remove the RH side by the same procedure as the LH side.
18. INSTALL REAR AXLE CARRIER BUSH LH
a. Align the matchmarks on the rear axle beam assy with the 2 notches of a new bushing and temporarily install the bushing to the rear axle beam
assy.