Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-681011.png)
a. Mount drive shaft in a soft vise.
b. Secure the clamp onto the boot.
c. Place SST onto the clamp.
SST 09S21-24010
d. Tighten the SST so that the clamp is pinched.
NOTICE: Do not overtighten the SST.
e. Using SST, measure the clearance of the clamp.
SST 09240-00020 (09242-00080)
Clearance: 0.8 mm (0.032 inch) or less
NOTICE: When the measured value exceeds the specified value, retighten the clamp.
39. INSTALL FRONT AXLE OUTBOARD JOINT BOOT LH CLAMP
a. Mount drive shaft in a soft vise.
b. Secure the clamp onto the boot.
c. Place SST onto the clamp.
SST 09521-24010
d. Tighten the SST so that the clamp is pinched.
NOTICE: Do not overtighten the SST.
e. Using SST, measure the clearance of the clamp.
