Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
3.
Remove Rear Door Pull Handle.
4.
Lift access cover and remove attaching screw from the Door Inside Handle Sub-Assembly.
5.
Remove Rear Door Trim Board Sub-Assembly (see diagram for clip location).
6.
Remove Door Glass Window Run.
7.
Install New Door Glass Window Run.
8.
Reassemble in reverse order.
NOTE:
Please refer to the 2003 Matrix Repair Manual, Vol. 2, pg. 75-18 for additional information.
If the Door Glass Run is loose:
Carefully reattach it using 3M Super Weatherstrip Adhesive, or equivalent.