MR2 L4-122 1998cc 20L DOHC Turbo (3S-GTE) Compressor Shaft Seal | Technical Service Bulletin
The following SST should be used for this procedure:
SST PART NUMBER
DESCRIPTION
07114-84010
Snap Ring Pliers
07112-85070
Lip Seal Remover
*07112-85050
Lip Seal Protector
*07112-85060
Lip Seal Pressor*
*These are new SST tools for the lip seal of 10P13 compressor.
Figure 1
REMOVAL OF LIP TYPE SHAFT SEAL
1. Use the Snap Ring Pliers (SST 07114-84010) to remove the snap ring (Figure 1).
Figure 2
2. Remove the Lip Seal
a) Set the Lip Seal Remover (SST 07112-85070) on the shaft seal (Figure 2).
Figure 3
b) Turn the Lip Seal Remover until the projection on it is aligned with the indentation of the lip seal (Figure 3).