MR2 L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
Fuel Pressure: Testing and Inspection
CAUTION:Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and the
negative (-) terminal cable is disconnected from the battery.
-
Check that the battery voltage is above 12 volts.
-
Disconnect the cable from the negative (-) terminal of the battery.
Union Bolt Removal
-
Put a suitable container or shop towel under the fuel filter.
-
Remove the union bolt and two gaskets, and disconnect the fuel inlet hose from the fuel filter outlet.
HINT: Slowly loosen the union bolt.
Gauge Connection
-
Install the fuel inlet hose and pressure gauge to the fuel filter outlet with three new gaskets and the union bolt.
Torque: 29 Nm (22 lb.ft)
-
Wipe off any splattered gasoline.
-
Reconnect the battery negative (-) cable.
Jumper Installation
-
Using a jumper wire, connect terminals +B and FP of the check connector.