MR2 L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
1. INSPECT CLUTCH PISTON
a. Check that the check ball is free by shaking the piston.
b. Check that the valve does not leak by applying low-pressure compressed air.
2. INSPECT DISC, PLATE AND FLANGE
Check if the sliding surface of the discs, plates and flanges are worn or burnt. If necessary, replace them.
HINT:
-
If the lining of the disc is exfoliated or discolored, or even a part of the printed numbers are defaced, replace all discs.
-
Before assembling new discs, soak them in ATF for at least fifteen minutes.
ASSEMBLY OF FORWARD CLUTCH
1. INSTALL OIL SEAL RINGS
Install the two oil seal rings to the shaft.
NOTE: Do not spread the ring ends more than necessary.
HINT: After installing the oil seal rings, check that they move smoothly.
2. INSTALL CLUTCH PISTON TO CLUTCH DRUM