MR2 L4-1587cc 1.6L DOHC (4A-GE) (1986)
Brake Caliper: Service and Repair
Disassembly and Reassembly
1.
Remove caliper as previously described.
2.
Remove two caliper sliding bushings, four dust boots and two collars.
3.
Using screwdriver, remove cylinder boot set ring and the cylinder boot.
4.
Place a piece of cloth between piston and cylinder and, using compressed air, remove piston from cylinder.
5.
Using a screwdriver, remove piston seal.
6.
Apply lithium soap base glycol grease to all moveable parts.
7.
Install piston seal and piston in cylinder.
8.
Install cylinder boot and set ring in cylinder.
9.
Install collar and dust boot, ensuring that boot is secured firmly to brake cylinder groove.
10.
Install bushing into boot, ensuring that boot is secured firmly to bushing groove.