MR2 L4-1587cc 1.6L DOHC (4A-GE) (1986)
/Page-325002.png)
1.
Install second brake apply gasket, then hold cam down and slip cable end into slot.
Fig. 4 Valve body installation
2.
Position valve body on transaxle, then insert attaching bolts, Fig. 4, and torque to 7 ft. lbs. Valve body bolt lengths (mm) are indicated in Fig. 4.
3.
Connect white shorter wire to No. 1 solenoid connector, then the longer black wire to the No. 2 solenoid connector.
4.
Align manual valve with pin on manual valve in place.
5.
Insert and finger tighten manual valve attaching bolts. Torque bolts to 7 ft. lbs.
6.
Install detent spring, then insert and finger tighten attaching bolts. Torque bolts to 7 ft. lbs. Ensure manual lever contacts center of roller at tip
of detent spring.
7.
Install oil tubes, then apply tube brackets.
8.
Install oil strainer, then insert attaching bolts and torque to 7 ft. lbs.
9.
Insert magnet into oil pan, then install oil pan with new gasket. Insert oil pan attaching bolts, then torque to 43 inch lbs.
10.
Install drain plug with new gasket and torque to 36 ft. lbs.
11.
Fill transaxle to specifications, then ensure fluid is at proper level.
12.
Lower, then road test vehicle.
