MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
/Page-1133002.png)
a. Connect the negative (-) lead from the ammeter to terminal 6, and the positive (+) lead to negative terminal of the battery.
b. Connect the negative (-) lead from the battery to terminal 5.
c. Check that the current changes from approximately 3.2 A to less than 0.5 A within 20 to 70 seconds.
d. Disconnect the leads from terminals.
e. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal 5 and the negative (-) lead to terminal 6, and check that
the door lock moves to the LOCK position.
If operation is not as specified, replace the door lock assembly.
INSPECT PASSENGER'S DOOR PTC THERMISTOR OPERATION
a. Connect the negative (-) lead from the ammeter to terminal 2, and the positive (+) lead to negative terminal of the battery.
b. Connect the negative (-) lead from the battery to terminal 1.
c. Check that the current changes from approximately 3.2 A to less than 0.5 A within 20 to 70 seconds.
d. Disconnect the leads from terminals.
