MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
/Page-1070005.png)
3. Move the SST at least 10 m (33 ft) away from the disc wheel.
NOTE: Take care not to damage the SST wire harness.
d. Activate the seat belt pretensioner.
1. Connect the SST red clip to the battery positive (+) terminal and black clip to the battery negative (-) terminal.
2. Check that no one is within 10 m (33 ft) are around the disc wheel.
3. Press the SST activation switch and activate the seat belt pretensioner.
HINT: The seat belt pretensioner operates simultaneously with the LED of the SST activation switch lighting up.
e. Dispose of the front seat outer belt with seat belt pretensioner.
CAUTION:
-
The front seat outer belt is very hot when the seat belt pretensioner is activated, so leave it alone for at least 30 minutes after activation.
-
Use gloves and safety glasses when handling front seat outer belt with activated seat belt pretensioner.
-
Always wash your hands with water after completing the operation.
-
Do not apply water, etc to front seat outer belt with activated seat belt pretensioner.
1. Remove the disc wheel and SST.
2. Place the front seat outer belt in vinyl bag, tie the end tightly and dispose of it in the same way as other general parts.
