Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
(b) Disconnect the connector from the Actuator.
3. Connect Actuator checker Special Service Tool (SST) to Actuator.
Sub-Wire Harness C And Sub-Wire Harness I
(a) Connect the Actuator checker (SST) to the Actuator, Control Relay and body side wire harness through the sub-wire harness C and I (SST), as
shown.
SST 09990 - 00150, 09990 - 00200, 09990 - 00300
(b) Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative ( - ) terminal. Connect the black cable
of the sub-wire harness to the battery negative ( - ) terminal or body ground.
(c) Place the "SHEET A" (SST) on the Actuator checker.
SST 09990 - 00163
4. Inspect brake Actuator operation.
(a) Start the engine, and run it at idle.
Holding MOTOR Switch On Actuator
(b) Turn the selector switch of the Actuator checker to the "FRONT RH" position.
(c) Push and hold in the MOTOR switch for a few seconds. Make sure that you can hear the motor run.
(d) Depress the Brake Pedal and hold it for about 15 seconds, and check the pedal does not go down.
Depressing Brake Pedal And MOTOR Switch
