Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
(c) Remove the Caliper and suspend it securely.
NOTE: Do not disconnect the flexible hose from the Caliper.
4. Remove these parts:
(a) 2 Brake Pads.
(b) 3 anti-squeal shims.
(c) Pad wear indicator plate.
(d) 4 pad support plates.
CAUTION: The support plates can be used again provided that they have sufficient rebound, no deformation, cracks or wear, and have had all
rust, dirt and foreign particles cleaned off.
5. Check Disc thickness and runout. Refer to Brake Caliper - Service and Repair. See: Brake Caliper/Service and Repair
6. Install the 4 pad support plates.
7. Install new pads.
CAUTION: When replacing worn pads, the anti-squeal shims and wear indicator plates must be replaced together with the pads.
(a) Install a pad wear indicator plate on the inner pad.
(b) Apply Disc brake grease to both sides of the inner anti-squeal shim.
(c) Install the anti-squeal shims to the outer pad.
(d) Install the anti-squeal shim to the inner pad.
(e) Install inner pad with the pad wear indicator plate facing upward.
(f) Install outer pad.
CAUTION: There should be no oil or grease adhering to the friction surfaces of the pads or the Disc.
8. Install Caliper.
9. Install front wheel.
10. Check that fluid level is at max line.
