Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
Remove Piston Stopper Bolt
Using a screwdriver, push the pistons in all the way and remove the piston stopper bolt and gasket.
NOTE: Tape the screwdriver tip before use.
Torque: 10 Nm (7 ft. lbs.)
5. Remove pistons.
Remove Pistons
(a) Push in the piston with a screwdriver and remove the snap ring with snap ring pliers.
(b) Remove the No.1 piston and spring by hand, pulling straight out, not at an angle.
CAUTION:
-
If pulled out and install at an angle, there is a possibility that the cylinder bore could be damaged.
-
Be careful not to damage the rubber lips on the pistons.
Remove Cylinder
(c) Place a rag and 2 wooden blocks on the work table and lightly tap the cylinder flange against the block edges until the No.2 piston drops out of
the cylinder.
NOTE: Make sure the distance (A) from the rag to the top of the blocks is at least 100 mm (3.94 inch).
INSPECTION
NOTE: Clean the disassembled parts with compressed air.
1. Inspect cylinder bore for rust or scoring.
2. Inspect cylinder for wear or damage.
If necessary, clean or replace the cylinder.
