Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
Crankshaft Rear Oil Seal: Service and Repair
REPLACEMENT
NOTE: There are 2 methods (A and B) to replace the oil seal which are as follows:
1. Replace crankshaft rear oil seal.
A. If Rear Oil Retainer Is Removed From Cylinder Block:
(a)
Using a screwdriver and hammer, tap out the oil seal.
(b) Using Special Service Tool (SST) or equivalent and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal edge.
SST 09223 - 15030, 09550 - 10012 (09552 - 10010)
(c)
Apply Multipurpose (MP) grease to the oil seal lip.
B. It rear oil seal retainer is installed to cylinder block:
(a)
Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
CAUTION: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(c)
Apply MP grease to a new oil seal lip.