Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
High-Tension Cord: Testing and Inspection
HIGH-TENSION CORDS INSPECTION
1. Disconnect high-tension cords from spark plugs
(a) Disconnect the high-tension cords at the rubber boot. Do not pull on the cords.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
(b) Disconnect the high-tension cords from the clamp.
2. Disconnect high-tension cords from ignition coils
(a) Using a screwdriver, lift up the lock claw and disconnect the holder from the ignition coils.
(b) Disconnect the high-tension cord at the grommet.
Do not pull on the cord.
NOTICE:
-
Pulling on or bending the cords may damage the conductor inside.
-
Do not wipe any of the oil from the grommet after the high-tension cord is disconnected.
3. Inspect high-tension cord resistance
Using an ohmmeter, measure the resistance.
Maximum resistance: 25 K ohms per cord
If the resistance is greater than maximum. check the terminals.
If necessary. replace the high-tension cord.
4. Reconnect high-tension cords to ignition coils.
(a) Assemble the holder and grommet.