Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
b. Using the 09608 - 04031 Special Service Tool (SST), press in the shaft with the bearing to the housing.
NOTE: Be careful not to damage the oil seal.
c. Using snap ring pliers, install a new snap ring to the front housing.
3. Using a plastic hammer, tap in two new straight pins to the front housing.
NOTE: Be careful not to damage the pins.
4. Install the cam ring with the inscribed mark facing outward, taking care to align the holes of the cam ring with the straight pins.
5. Install the vane pump rotor by doing the following.
a. Install the rotor with the inscribed mark facing outward.
b. Using snap ring pliers, install a new snap ring to the vane pump shaft.
6. Install the 10 vane plates with the round end facing outward.
7. Install a new gasket on the front housing.
8. Align the holes of the side plate and straight pins, and install the side plate.
9. Install the wave washer so that its protrusions fit into the slots in the side plate.
10. Install the rear housing by doing the following.
a. Coat two new O-rings with power steering fluid and install them to the housing.
b. Tighten the two bolts to 24 Nm (17 ft. lbs.).
