Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
^
Use the 09922 - 10010 SST in the direction shown in the illustration.
^
Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and a hammer, stake the washer.
NOTE: Avoid any implant to the rack.
16. Install the right and left hand rack boots, clamps and clips by doing the following.
a. Ensure that the steering rack hole is not clogged with grease. If the hole is clogged, the pressure inside the boot will change after it is
assembled and the steering wheel turned.
b. Install the boot.
NOTE: Be careful not to damage or twist the boots.
c. Tighten a new clamp, as shown in the illustration.
d. Install the clip, face the open ends of the clip outward / upward, as shown.
17. Install the right and left hand tie rod ends and lock nuts by doing the following.
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, tighten the nut to 47 Nm (35 ft. lbs.).
18. Install the air control valve, then tighten the valve down to 29 Nm (22 ft. lbs.).
