Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
NOTICE:
-
The hub bearing could be damaged if it is subjected to the vehicle weight, such as when moving the vehicle with the drive shaft removed.
Therefore, if it is absolutely necessary to place the vehicle weight on the hub bearing, first support it with Special Service Tool (SST)
09608-16042 (09608-02021, 09608-02041) or equivalent.
-
w/ ABS: After disconnecting the drive shaft from the axle hub, work carefully so as not to damage the sensor rotor serrations on the drive shaft.
1. Remove front wheel.
Torque: 103 Nm (76 ft. lbs.)
2. M/T: Remove Left-Hand (LH) engine under cover.
3. Drain transaxle oil (M/T) or ATF (A/T).
4. w/ ABS: Remove bolt and ABS speed sensor.
Torque: 8.0 Nm (71 inch lbs.)
5. Remove drive shaft lock nut.
a. Remove the cotter pin and lock cap.
b. While applying the brakes, remove the nut.
Torque: 216 Nm (159 ft. lbs.)
6. Disconnect tie rod end from steering knuckle.
a. Remove the cotter pin and nut.
Torque: 49 Nm (36 ft. lbs.)
b. Using Special Service Tool (SST) 09628-62011 or equivalent, disconnect the tie rod end from the steering knuckle.
