Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
7. Disconnect lower ball joint from lower suspension arm.
Remove the 2 nuts and bolt.
Torque: 80 Nm (59 ft. lbs.)
8. Disconnect drive shaft from axle hub.
NOTICE: Be careful not to damage the drive shaft boot and inner oil seal.
9. Left-Hand (LH) drive shaft: Remove drive shaft.
a. M/T: Using a hammer, remove the drive shaft.
b. A/T: Using a hammer and hub nut wrench or an equivalent, remove the drive shaft.
10. Right-Hand (RH) drive shaft: Remove drive shaft.
Using a brass bar and hammer, remove the drive shaft.
11. Remove snap ring.
Using a screwdriver, remove the snap ring from the inboard joint shaft.
INSTALLATION
Installation is in the reverse order of removal.
1. INSTALL NEW SNAP RING
Using a snap ring expander, install a new snap ring to the inboard joint.
2. INSTALL DRIVE SHAFT