Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
6. CONNECT TIE ROD END TO STEERING KNUCKLE
(a) Connect the tie rod end to steering knuckle and tighten the nut.
Torque: 49 N.m (500 kgf.cm, 36 ft.lbf)
(b) Install a new cotter pin.
HINT: If the cotter pin does not line up, correct by tightening the nut by the smallest amount possible.
7. INSTALL DRIVE SHAFT LOCK NUT
(a) Tighten the lock nut.
Torque: 206 N.m (2,100 kgf.cm, 152 ft.lbf)
(b) Install the lock cap and a new cotter pin.
HINT: If the cotter pin does not line up, correct by tightening the nut by the smallest amount possible.
8. INSTALL ENGINE UNDER COVER
9
INSTALL FRONT WHEEL AND LOWER VEHICLE
Torque: 103 N.m (1,050 kgf.cm, 76 ft.lbf)
10. INSPECT FRONT WHEEL ALIGNMENT
After installation, check ABS speed sensor signal and front wheel alignment.
Disassembly / Assembly
