Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
b. Using the 09628 - 62011 Special Service Tool(SST), disconnect the tie rod end from the steering knuckle.
NOTE: When installing the tie rod end, tighten the nut to 49 Nm (36 ft. lbs.).
9. Disconnect the lower ball joint from the lower suspension arm after first removing the two nuts and bolt.
NOTE: When installing the ball joint tighten the nuts and the bolt to 80 Nm (59 ft. lbs.).
10. Remove the steering knuckle with the axle hub after doing the following.
a. Remove the two nuts and bolts on the lower side of the shock absorber.
b. Remove the steering knuckle with the axle hub.
NOTE: Be careful not to damage the oil seal with the drive shaft.
INSTALLATION
7. Reverse the removal procedure to install, noting the following:
-
check the ABS speed sensor signal.
-
check the front wheel alignment.
Disassembly / Assembly
