Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
Input Shaft: Service and Repair
NOTE: For removal and installation procedures refer to "Manual Transmission/Transaxle, Service and Repair."
INPUT SHAFT DISASSEMBLY
1. Inspect 3rd and 4th gears thrust clearance.
Using a feeler gauge, measure the thrust clearance.
Standard clearance:
3rd gear: 0.10 - 0.35 mm (0.0039 - 0.0138 in.)
4th gear: 0.10 - 0.55 mm (0.0039 - 0.0217 in.)
Maximum clearance:
3rd gear: 0.40 mm (0.0157 in.)
4th gear: 0.60 mm (0.0236 in.)
2. Inspect 3rd and 4th gears radial clearance.
Using a dial indicator, measure the radial clearance between the gear and shaft.
Standard clearance: 0.015 - 0.058 mm (0.0006 - 0.0023 in.)
Maximum clearance: 0.070 mm (0.0028 in.)
If the clearance exceeds the maximum, replace the gear, needle roller bearing or shaft.
3. Remove snap ring.
