Toyota Workshop Service and Repair Manuals

Output Shaft: Specifications

SERVICE SPECIFICATIONS 

Output Shaft:

Roller Bearing Journal Diameter:

Minimum ..........................................................................................................................................................................  32.970 mm (1.2980 in.)

1st Gear Journal Diameter:

Minimum ..........................................................................................................................................................................  37.970 mm (1.4949 in.)

2nd Gear Journal Diameter:

Minimum ..........................................................................................................................................................................  31.970 mm (1.2587 in.)

Runout:

Maximum .............................................................................................................................................................................  0.05 mm (0.0020 in.)

TORQUE SPECIFICATIONS 

Output Shaft:

Front Bearing Lock Plate Set Bolt .................................................................................................................................  11 Nm (115 kgf/cm, 8 ft.lbs.)
Lock Nut ..................................................................................................................................................................  118 Nm (1200 kgf/cm, 87 ft.lbs.)