Paseo Coupe L4-1497cc 1.5L DOHC MFI (1997)
Standard clearance: 0.015 - 0.058 mm (0.0006 - 0.0023 in.)
Maximum clearance: 0.070 mm (0.0028 in.)
If the clearance exceeds the maximum, replace the gear, needle roller bearing or shaft.
3. Remove rear ball bearing, 4th driven gear and output gear spacer from output shaft.
Using SST 09950 - 00020 and a press, remove the rear ball bearing and 4th driven gear.
b. Remove the output near spacer.
4. Remove 3rd driven gear, 2nd gear, needle roller bearing and synchronizer ring.
a. Shift the No.1 hub sleeve into the 1st gear.
b. Using SST 09950 - 00020 and a press, remove the 3rd driven gear and 2nd gear.
c. Remove the needle roller ring bearing and synchronizer
5. Remove snap ring.
Using 2 screwdrivers and a hammer, tap out the snap ring.
6. Remove No.1 hub sleeve assembly, 1st gear, synchronizer ring, needle roller bearing, thrust washer and ball.
a. Using a press, remove the No.1 hub sleeve assembly, 1st gear and synchronizer ring.
Remove the needle roller bearing, thrust washer and ball.
