Pickup 2WD L4-2366cc 2.4L SOHC Turbo (22R-TE) (1987)
/Page-694001.png)
Valve Body: Service and Repair
Removal
1.
Disconnect battery ground cable, then clean exterior of transmission.
2.
Raise and support vehicle, then drain transmission fluid.
3.
Remove oil pan, filler tube and gasket.
4.
On A340E models, remove three attaching bolts, then oil strainer and gasket.
5.
On A340H models, remove eleven attaching bolts, oil strainer and gasket, then the five attaching bolts and oil strainer case.
6.
On all models, note position of oil tubes to facilitate installation, then remove oil tubes.
7.
Disconnect solenoid electrical connectors.
8.
Remove valve body attaching screws, then the CO, B2 and C2 accumulator piston springs with B2 and C2 piston spacers.
9.
Disconnect throttle cable from cam then remove valve body.
Installation
1.
Connect throttle cable to cam.
2.
Align manual valve lever with manual valve, then install CO, B2 and C2 accumulator piston springs with B2 and C2 piston spacers.
Fig. 4 Valve body bolt installation. Except Cressida W/A340E
Fig. 5 Valve body bolt installation. Cressida W/A340E
3.
Install valve body attaching bolts as shown, Figs. 4 and 5, then torque to 7 ft. lbs.
4.
Connect electrical connector to each solenoid.
5.
Install oil tubes in original position.
6.
On A340E models, install oil strainer with new gasket, then torque attaching bolts to 7 ft. lbs.
7.
On A340H models, install oil strainer case, then torque attaching bolts to 7 ft. lbs. Install oil strainer with new gasket, then torque strainer
