Pickup 4WD L4-144.4 2366cc 2.4L SOHC (22R-E) (1986)
/Page-724002.png)
Fig. 2 Throttle cable adjustment
THROTTLE CABLE
1.
Fully depress accelerator pedal, then ensure throttle valve is fully open.
2.
With accelerator pedal fully depressed, loosen throttle valve adjustment nuts, Fig. 2.
3.
Adjust cable housing until distance between end of boot and stopper on cable is 0-.04 inch.
4.
Tighten adjusting nuts, then recheck adjustment.
TRANSFER LINKAGE
1.
Place transfer lever in ``H2'' position.
2.
Disconnect No. 1 transfer linkage from cross shaft.
3.
Position transfer indicator switch in ``H2'' position.
4.
Connect No. 1 transfer linkage from cross shaft.
Fig. 3 Transfer indicator switch adjustment
