Pickup 4WD L4-2366cc 2.4L SOHC Turbo (22R-TE) (1986)
/Page-769001.png)
Stabilizer Bar: Service and Repair
W/4 WHEEL DRIVE
1.
Remove stabilizer bar to lower suspension arms retaining nuts, cushions and retainers.
2.
Disconnect stabilizer bar.
3.
Remove stabilizer bar brackets and cushions, then the stabilizer bar.
4.
Place stabilizer bar in position, then install new cushion and brackets to frame and insert attaching bolts.
5.
Connect stabilizer bar on both sides to lower arms with attaching bolts, retainers and nuts, then torque nuts to 19 ft. lbs. on Pickup models, or 14 ft.
lbs. on Van models.
6.
Torque bracket set bolts to 9 ft. lbs. on Pickup models, or 14 ft. lbs. on Van models.
W/2 WHEEL DRIVE
1.
Remove one torsion bar as described under ``Lower Control Arm & Torsion Bar, Replace.''
2.
Remove stabilizer bar from lower control arms.
3.
Remove stabilizer brackets and bushings from frame, then remove stabilizer bar.
4.
Reverse procedure to install.
