Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1990)
/Page-1046002.png)
4. (C&C)
RAISE FRONT BRAKE PRESSURE TO 11,768 kPa (120 kgf/cm2, 1,707 psi) AND CHECK REAR BRAKE PRESSURE
Rear brake pressure:
SRW 9,709 ± 588 kPa (99 ± 6 kgf/cm2, 1,408 ± 85 psi)
DRW 8,336 ± 588 kPa (85 ± 6 kgf/cm2, 1,209 ± 85 psi)
5. IF NECESSARY, ADJUST FLUID PRESSURE
(a) Adjust the length of the No.2 shackle.
Low pressure: Lengthen A
High pressure: Shorten A
Initial set:
2WD: 78 mm (3.07 in.)
4WD: 120 mm (4.72 in.)
Adjusting range:
2WD: 72 - 84 mm (2.83 - 3.31 in.)
4WD: 114 - 126 mm (4.49 - 4.96 in.)
HINT: One turn of the nut changes the fluid pressure as shown in the table below.
(b) In event the pressure cannot be adjusted by the No.1 shackle, raise or lower the valve body.
Low pressure - Lower
High pressure - Raise
(c) Torque the nuts.
