Pickup 4WD V6-180.5 2959cc 3.0L SOHC (3VZ-E) (1990)
/Page-294003.png)
(c) Place a new 0-ring into the groove of cylinder block.
(d) Install the oil pump to the crankshaft with the spline teeth of the drive rotor engaged with the large teeth of the crankshaft.
(e) Install the oil pump with the seven bolts.
Torque: 20 N.m (200 kgf.cm, 14 ft.lbf)
2. CLEAN OIL PAN BAFFLE PLATE AND OIL PAN
Remove any old packing (FIPG) material and be careful not to drop any oil on the contacting surfaces of the oil pan baffle plate, oil pan, cylinder
block and sealing grooves.
^ Using a razor blade and gasket scraper, remove all the remaining seal packing (FIPG) material from the gasket surfaces.
^ Thoroughly clean all components to remove all the loose material.
^ Clean both sealing surfaces with a non-residue solvent.
NOTICE: Do not use a solvent which will affect the painted surfaces.
3. INSTALL OIL PAN BAFFLE PLATE
Apply seal packing to the baffle plate as shown in the illustration.
Seal packing: Part No.08826-00080 or equivalent
^ Install a nozzle that has been cut to a 3 - 4 mm (0.12 - 0.16 in.) opening.
HINT: Avoid applying an excess amount to the surface.
^ If parts are not assembled within 5 minutes of applying the seal packing, the effectiveness of the seal packing is lost and the seal packing must
be removed and reapplied.
^ Immediately remove the nozzle from the tube and reinstall the cap after using the seal packing
