toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Hydraulic Control Assembly - Antilock Brakes|Specifications|Page 4995 > < Hydraulic Control Assembly - Antilock Brakes|Specifications|Page 4993
Page 3
background image

(a) Turn the selector switch to the "REAR" position.
(b) Repeating (c) to (j) to the step 4 check the Actuator operation similarly.
(c) Similarly, inspect "FRONT LH" wheel.

NOTE:  When inspecting the "FRONT LH" wheel. push the FRONT LH switch instead of the POWER switch. This makes it possible to
inspect wherever the selector switch position indicates.

6. Push SUB MOTOR switch.

(a) Push and hold in the MOTOR switch for a few seconds.
(b) Stop the engine.

7. Disconnect Actuator checker (SST) from Actuator.

Disconnect the Actuator checker (SST) and sub-wire harnesses (SST) from the Actuator, Control Relay and body side wire harness.
SST 09990-00150, 09990-00200, 09990-00300, 09990-00420

8. Connect connectors.

(a) Connect the 2 connectors to the control relay.
(b) Connect the connector to the Actuator.

9. Clear the Diagnostic Trouble Codes (DTC).

Hydraulic Control Assembly - Antilock Brakes|Specifications|Page 4995 > < Hydraulic Control Assembly - Antilock Brakes|Specifications|Page 4993