Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
Front Crankshaft Seal: Service and Repair
NOTE: There are 2 methods (A and B) to replace the oil seal which are as follows:
1. Replace crankshaft front oil seal.
A. If Oil Pump Is Removed From Cylinder Block:
(a)
Using a screwdriver, pry out the oil seal.
(b) Using Special Service Tool (SST) Transmission Rear Bearing Replacer # 09309 - 36010 or equivalent and a hammer, tap in a new oil
seal until its surface is flush with the oil pump case edge.
(c)
Apply Multipurpose (MP) grease to the oil seal lip.
B. If Oil Pump Is Installed To Timing Chain Case:
(a)
Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(b) Apply MP grease to a new oil seal lip.