Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
Timing Chain: Service and Repair
Installation
1. Install crankshaft timing gear.
(a) Turn the crankshaft until the shaft key is on the top.
(b) Slide the gear over the key on the crankshaft.
NOTE: If the gear is difficult to install by hand, install it using Special Service Tool (SST) Front Hub Inner Bearing Cone Replacer #
09608-06041 or equivalent.
2. Install No. 2 timing chain and idle gear.
(a) Place the No. 2 timing chain on the idle gear.
(b) Place the No. 2 timing chain on the crankshaft gear.
(c) Install and torque the 2 bolts.
Torque: 20 Nm (200 kg.cm, 14 ft. lbs.)
(d) Loosen the bolt (A) so that the chain guide presses against the chain.
(e) Check that the spring is operating normally against the chain guide by pressing on the chain with your finger and then releasing your finger.
