Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
DISTRIBUTOR INSTALLATION
1. Set No.1 cylinder to TDC/compression.
(a) Turn the equipment drive pulley clockwise. and potion the slit of the exhaust camshaft as shown.
(b) Remove the service bolt and nut.
NOTICE: It the service bolt and nut are not removed, the bolt head will hit and damage the cooling tan.
2. Install distributor.
(a) Install a new O-ring to the distributor.
HINT: Always use a new O-ring when installing the distributor.
(b) Align the cut out of the coupling with the groove of the distributor housing.
(c) Apply a light coat of the engine oil on the O-ring.
(d) Insert the distributor. aligning the center of the distributor housing flange with the bolt hole on the cylinder head.
(e) Lightly tighten the hold-down bolts.
