Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
12. Install rack guide spring cap lock nut.
a. Apply sealant to 2 or 3 threads of the nut.
Sealant: Part No. 08833 - 00080, THREE BOND 1344, LOCTITE 242 or equivalent.
b. Using a hexagon wrench (21 mm) to hold the rack guide spring cap, and using SST, torque the nut.
SST 09922 - 10010 or equivalent.
Torque: 48 Nm (36 ft. lbs.)
NOTICE: Use SST 09922 - 10010 or equivalent in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Recheck the total preload.
Preload (turning): 1.1 - 1.6 Nm (9.6 - 13.9 inch lbs.)
d. Remove the RH and LH rack ends.
13. Install RH and LH claw washers and rack ends.
a. Install a new claw washer, and temporarily tighten the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST, torque the rack end.
SST 09922 - 10010 or equivalent.
Torque: 75 Nm (55 ft. lbs.)
NOTICE: Use SST 09922 - 10010 or equivalent in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact to the rack.
14. Install RH and LH rack boots, clamps and clips.