Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
a. Ensure that the steering rack hole is not clogged with grease.
HINT: If the hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.
b. Install the boot.
NOTICE: Be careful not to damage or twist the boot.
c. Using pliers tighten a new clamp, as shown in the illustration.
HINT: Place the projection within the arrow.
15. Install RH and LH tie rod ends and lock nuts.
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, torque the nut.
Torque: 91 Nm (67 ft. lbs.)
16. Install 2 turn pressure tubes. Using SST, install the tube.
SST 09633 - 00020 or equivalent.
Torque: 20 Nm (15 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.
