Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
6. Disconnect tie rod end from steering knuckle.
a. Remove the cotter pin and nut.
Torque: 49 Nm (36 ft. lbs.)
b. Using Special Service Tool (SST) # 09628 - 10011 or equivalent, disconnect the tie rod end from the steering knuckle.
7. Disconnect lower ballpoint from steering knuckle.
Remove the 2 bolts.
Torque: 127 Nm (94 ft. lbs.)
8. Remove steering knuckle with axle hub.
a. Remove the 2 nuts and bolts on the lower side of the shock absorber.
b. Remove the steering knuckle with the axle hub.
NOTICE: Be careful not to damage the oil seal. and drive shaft boot and ABS speed sensor rotor.
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check the ABS speed sensor signal and front wheel alignment.
