Previa Van LE 4WD L4-2438cc 2.4L DOHC SC MFI (1997)
Maximum runout: Shaft: 2.0 mm (0.079 inch)
Flange: 0.2 mm (0.008 inch)
If the axle shaft or flange are damage or worn, or if runout is greater than maximum, replace the rear axle shaft.
3. Inspect axle bearing. Check that the bearing rotates smoothly.
4. w/ABS: Remove oil seal. Using SST # 09950 - 00020 or equivalent and a press, remove the oil seal.
5. w/ABS: Remove ABS speed sensor rotor. Using SST # 09950 - 00020 or equivalent and a press, remove the ABS speed sensor rotor.
6. Remove bearing inner retainer.
a. Using a grinder, grind down the inner retainer.
b. Using a chisel and hammer, cut off the retainer and remove it from the shaft.
7. Remove bearing.
a. Using SST # 09527 - 30010 or equivalent and a press, remove the bearing.
b. Remove the bearing outer retainer.
8. Disc brake: Assemble bearing outer retainer and backing plate.
a. Place a new retainer gasket and bearing outer retainer on the backing plate.
b. Using a socket wrench and hammer, install the 4 bolts.
9. Install bearing.
a. Drum brake: Install the bearing outer retainer to the axle shaft.
b. Disc brake: Install the backing plate to the axle shaft.
