toyota Workshop Repair Guides

Toyota Prius Hybrid Workshop Service and Auto Repair Manuals

Fuel/Hybrid System - MIL ON/DTC's P3101/P3190/P3191|Page 2817 > < Fuel/Hybrid System - MIL ON/DTC's P3101/P3190/P3191|Page 2815
Page 4
background image

^ To verify if a vehicle ran out of fuel, check the HV-ECU FFD for P3101 information code 204 or 205 "Exclusive Information 3" Data. If Exclusive

Information 3 value is 1, then the system detected an "out of fuel" condition. (See Figure 2.)

^ Fuel injection system

^ Ignition system (example: worn or dirty spark plugs)

^

Poor engine compression

^

Correct engine oil viscosity and level (refer to the Owner's Manual for recommendations). If overfilled, check intake manifold for contamination.

If NO trouble is found in the general trouble areas, follow the procedures below to isolate other potential causes.

Diagnostic Procedure

Save all Freeze Frame Data (FFD) and follow the chart.

Repair Procedure 1: Clean Throttle Body

1. Remove the air cleaner assembly.

Fuel/Hybrid System - MIL ON/DTC's P3101/P3190/P3191|Page 2817 > < Fuel/Hybrid System - MIL ON/DTC's P3101/P3190/P3191|Page 2815