Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
4. CONFIRM SUBSCRIPTION MODE
(a) Confirm the indicator status at 5 seconds after the power switch on (IG).
Result:
B -- REPLACE DCM (TELEMATICS TRANSCEIVER)
A -- END
5. REPLACE DCM (TELEMATICS TRANSCEIVER)
(a) Replace the DCM (Telematics Transceiver) See: Service and Repair/Removal.
NOTICE:
*
The power switch must be off.
*
Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT -- PERFORM DCM ACTIVATION See: Scan Tool Testing and Procedures/DCM Activation
6. CHECK DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG) and wait for 10 seconds.
(d) Turn the Techstream on.
(e) Perform "HEALTH CHECK" and check for current DTCs See: Initial Inspection and Diagnostic Overview/Health Check.
Result:
B -- GO TO DIAGNOSTIC TROUBLE CODE CHART See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Descriptions/Safety Connect System
A -- Continue to next step.
7. REPLACE DCM (TELEMATICS TRANSCEIVER)
(a) Replace the DCM (Telematics Transceiver) See: Service and Repair/Removal.
NOTICE:
*
The power switch must be off.
*
Do not swap the DCM (Telematics Transceiver) with one from another vehicle.
NEXT -- PERFORM DCM ACTIVATION See: Scan Tool Testing and Procedures/DCM Activation
Problem Symptoms Table
CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: PROBLEM SYMPTOMS TABLE
HINT
*
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of