toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 7551 > < Initial Inspection and Diagnostic Overview|Page 7549
Page 5
background image

NOTICE:
The BUB (Back-Up Battery) must not be replaced while an ACN call is in progress.

HINT
After ACN call end utility has been completed, BUB (Back-Up Battery) must be replaced.

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Choose "Telematics" from the System Selection Menu, and then click "Utility".

(e) Click "DCM Service" on the Utility Selection Menu.

(f) Choose "ACN call end" and then click "Next" on the DCM Service Utility.

(g) Follow the instructions by Techstream.

Green and Red Indicators Blink Simultaneously

CELLULAR COMMUNICATION: SAFETY CONNECT SYSTEM: GREEN AND RED INDICATORS BLINK SIMULTANEOUSLY
 - GREEN AND RED INDICATORS BLINK SIMULTANEOUSLY

DESCRIPTION

After the power switch on (IG), the DCM (Telematics Transceiver) will enter into a self check mode. The manual (SOS) switch red indicator will
illuminate for 2 seconds and turn off followed by the manual (SOS) switch green indicator illuminating and remaining on under normal operation.

If both indicators illuminate and begin to blink simultaneously, this indicates that the DCM (Telematics Transceiver) is in "Shipping Mode." If no DTCs
are present, both the green and red indicators will turn off after blinking. The activation sequence must be performed.

HINT
In shipping mode, the system will attempt to activate to shell mode automatically at each power switch on (IG).

INSPECTION PROCEDURE

PROCEDURE

1. CHANGE SUBSCRIPTION MODE

(a) Turn the power switch on (IG).

(b) Push the manual (SOS) switch.

(c) The vehicle will issue a voice prompt: "Safety Connect is not initialized. To activate, please press the button again within 5 seconds."

(d) Push the manual (SOS) switch and a beep will be emitted.

(e) That telematics service provider will send an End Call command and the manual (SOS) switch green indicator will illuminate.

(f) A voice prompt will state: "Activation Complete" (This may take up to 3 minutes)

(g) Turn the power switch off.

Initial Inspection and Diagnostic Overview|Page 7551 > < Initial Inspection and Diagnostic Overview|Page 7549