Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
_hybrid/Page-871003.png)
21. DISCONNECT HYBRID BATTERY JUNCTION BLOCK
CAUTION:
Wear insulating gloves.
NOTICE:
Insulate the removed terminals with insulating tape.
(a) Remove the 2 nuts, then disconnect the frame wire from the hybrid battery junction block.
(b) Disconnect the clamp and frame wire.
22. REMOVE FRAME WIRE
CAUTION:
Wear insulating gloves.
NOTICE:
Insulate the removed terminals with insulating tape.
(a) Remove the wire harness protector and disconnect the clamp from the floor panel.
(b) Disconnect the 2 wire harness clamps from the floor panel.
(c) Disconnect the 3 claws and push the frame wire out from the floor panel.
(d) Disconnect the connector from the engine room junction block assembly.
