Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
_hybrid/Page-872002.png)
(f) Install the heater water pipe sub-assembly and nut.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
(g) Connect the clamp shown in the illustration.
(h) Connect the clamp shown in the illustration.
(i) Connect the 2 clamps shown in the illustration.
(j) Connect the connector to the engine room junction block assembly.
(k) Connect the 2 wire harness clamps to the floor panel.
(l) Install the wire harness protector and connect the clamp to the floor panel.
2. CONNECT HYBRID BATTERY JUNCTION BLOCK
CAUTION:
