Prius L4-1.8L (2ZR-FXE) Hybrid (2010)
parts.
*
Make sure that the pin (stopper) is securely inserted into the body hole.
*
Tighten the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.
(d) Connect the connector to the front airbag sensor.
NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.
(1) Before connecting the connector, check that the position of the white housing lock is correct as shown in the illustration.
(2) Be sure to engage the connectors until they are locked (when locking, make sure that a click sound can be heard).
HINT
When engaged, the white housing lock will slide. Be sure not to hold the white housing lock and part (A), as it may result in an
insecure fit.
(e) Check that there is no looseness in the installation parts of the front airbag sensor.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected See: Testing and
Inspection/Programming and Relearning.
3. INSTALL REAR NO. 3 FLOOR BOARD See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
4. INSTALL REAR DECK FLOOR BOX See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal and
Replacement/Installation
5. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal and Replacement/Installation